Several questions about the bending radius of the fully enclosed towline

When selecting towlines, fully enclosed towline plastic manufacturers must also have certain specifications for the length, overall width, inner height, inner width, and bending radius of the towline. Master, if the model is selected incorrectly, it may directly affect the operation of the entire facility.

1. Frequently asked questions about choosing the bending radius: the appropriate selection of the bending radius also depends on the specific height of the indoor space. The bending radius should be smaller than the height of the idle space of the mechanical equipment. The radius should also exceed 10 times the maximum diameter of the cable. The selection range is 75-650mm, and the schedule is small to choose a drag chain with a small bending radius.

2. Accurately measure the bending radius of the towline: bend and fold the towline, find the vertical high and low points, and accurately measure the distance between two connection points, high quality The bending radius of the fully enclosed drag chain is equal to half of the accurately measured diameter.

3. The total bending height of the towline = bending radius * 2 + the outer height of the towline, such as the plastic towline 35*75 specification model, the height of which is 25mm, and the outer height is 55mm. Then it has a bending radius of 75/100/125/150/200 and so on. For example, if the radius is 75, the slope of the bottom line is 205. The calculation method is radius 75×2, and then the outer height is 55, and the result is 205mm. On the contrary, calculating the radius of the plastic drag chain is to measure the total slope height, subtract the outer height, and then divide it by 2, which is the radius.

4. Calculation method of bending radius of antistatic fully enclosed drag chain: drag chain bending radius = (total height of drag chain after bending - thickness of drag chain) / 2, drag chain The larger the bending radius, the higher the total bending height.